SignaMax 065-7714HSFPTB User Manual download pdf (Page 136)

Hardened Managed Ethernet Switch

User’s Manual 135

VLAN

VLAN Mode Setting, 802.1Q VLAN Setting, 802.1Q Port Setting, Port Based

VLAN

802.1Q VLAN Setting

VLAN Database:

1. Command Mode: Configure mode

Logon to Configure Mode (Configure Terminal Mode).

The switch_a(config)# prompt will show on the screen.

switch_a(config)#

2. Usage:

Use vlan database command to enter the VLAN configuration mode.

3. Command Syntax:

vlan database

4. Example:

The following example changes to VLAN configuration mode from Configure

mode:

switch_a(config)#vlan database

switch_a(config-vlan)#

Add VLAN/Delete VLAN:

1. Command Mode: VLAN Configure mode

Logon to Configure Mode (Configure Terminal Mode).

Logon to VLAN Configure Mode.

The switch_a(config-vlan)# prompt will show on the screen.

switch_a(config)#vlan database

switch_a(config-vlan)#

2. Usage:

This command enables or disables the state of a particular VLAN on a bridge

basis. Specifying the disable state causes all forwarding over the specified

VLAN ID on the specified bridge to cease. Specifying the enable state allows

forwarding of frames on the specified VLAN-aware bridge.

3. Command Syntax:

vlan VLANID bridge GROUP name VLAN_NAME state enable/disable

no vlan VLANID bridge GROUP

VLANID The VID of the VLAN that will be enabled or disabled on the bridge

<2-4094>.

1 2 ... 131 132 133 134 135 136 137 138 139 140 141 ... 177 178

No comments

SignaMax 065-7714HSFPTB User Manual Page 136